5 1/2 Bending Pliers 1.5-2.0mm 12.5 cm (5.0)

5 1/2 Bending Pliers for Precise Wire and Plate Contouring

These 5 1/2-inch bending pliers give surgeons and OR staff a controlled, repeatable way to contour wire and small plates in orthopedic, trauma, and general surgical procedures. The 12.5 cm (5.0 inch) length balances reach with maneuverability, while the 1.5–2.0 mm working range suits fine wire and light plate work. The plier jaws are shaped to bend without crushing, helping preserve material integrity at the bend point. Built for the demands of hospital and ambulatory surgery center environments, they are easy to clean, inspect, and sterilize between cases. A dependable choice for trays that need a compact, precise bending instrument.

• Contouring orthopedic wire and small plates during fracture fixation and trauma procedures
• Shaping cerclage wire and K-wires in the operating room
• Adjusting light-gauge wire in general and plastic surgery cases
• Fine bending tasks in ASC and clinic procedure trays
• Supporting accurate implant and hardware preparation before placement

• Clean and remove debris from the jaws and hinge after each use
• Inspect jaw alignment and hinge action before sterilization
• Sterilize according to your facility's validated steam or low-temperature cycle
• Store in a dry, protected tray to prevent corrosion and jaw damage

For use by trained healthcare professionals. Confirm instrument suitability and sterilization parameters with your facility's protocols.