Swedish Pattern Needle Holder 6, Tungsten Carbide Tip

Controlled Needle Handling in a Practical 6-Inch Design

The Swedish Pattern Needle Holder 6″, Tungsten Carbide Tip is designed to hold and manipulate suture needles during suturing work. Its 6-inch overall length provides a practical balance between working reach and instrument control, while the tungsten carbide tip identifies the gripping component used for needle handling. This configuration supports organized, precise instrument movement in workflows that require dependable needle positioning and transfer. The Swedish pattern design offers a familiar format for professionals seeking a dedicated needle holder for routine suturing tasks without adding unnecessary complexity to the instrument setup.

Use Cases

• Hold and manipulate suture needles during suturing tasks.
• Support controlled needle positioning and transfer within an instrument workflow.
• Use the 6-inch format where a moderate working length is appropriate for needle handling.
• Incorporate the tungsten carbide tip into workflows requiring a dedicated gripping surface for suture needles.

Specifications

Care & Handling

• Clean the instrument promptly after use according to facility protocols and the applicable instructions for use.
• Inspect the jaws and tungsten carbide tip for retained debris, damage, alignment, or visible wear before handling suture needles.
• Handle the instrument carefully to protect the tip from impact, abrasion, or contact with other instruments.
• Store the cleaned instrument in a manner that protects its working end and follows facility protocols.

Specifications

General use; follow facility protocols.